The Vaporstar is the best evaporator solution if you don't want to do without your bong. Just put the Vaporstar into the bowl. The vaporstar fits all bowls with a 14, 5mm connector size - in this set, we have included a glass adapter so your Vaporstar will fit 18, 8mm bongs, too.

• How to use the Vaporstar

• 1. Fill the bowl with herb but don't overfill it.
• 2. Slide the Vaporstar into the wooden bowl with one of the three visible lines pointing towards you.
• 3. Put your thumb over the hole on the rear, raise the pipe to your mouth and ignite the lighter. Hover the flame about 1 cm from the top of the Vaporstar tube.
• 4. Inhale gently with the flame always dipping into the Vaporstar. When the Vaporstar is still cold, inhale for 5-6 seconds, when it's already warm 1-3 seconds. You can hear a quiet whistling.
• 5. Continue until vapor begins to fill the chamber. Then extinguish your lighter but continue to inhale until all the vapor has cleared.
• 6. When the chamber is clear of vapor, drop your thumb from the hole in the back of the pipe and increase suction.
• 7. Twist the wooden bowl one third of a revolution and then repeat from step 3 twice more.
• 8. Using the tweezers (!) remove the Vaporstar from the bowl and tap out the dried plant into your hand.
• 9. Rub the dried plant into a rough powder and then scoop it back into the bowl.
• 10. Repeat steps 3 to 7, then remove the Vaporstar from the bowl and agitate the remaining powder with the tweezers tool. Repeat steps 3 to 6 one last time.

Inhale slowly to heat the Vaporstar quickly. When you see vapor remove the flame, increase the suction to air cool the Vaporstar, therefore avoiding excessive heat, burning and smoke.